Product details:

Their strong yet compact, thin wall construction allows them to fit into those tight spots commonly found on shift linkages of mid-engine cars. Each joint is permanently lubricated and covered with a silicone rubber boot to exclude dirt. They are designed for cross-bolting, pinning, or welding to a close fitting shaft or torque tube. (Welding must be done carefully to prevent heat damage. ) Maximum operation angle 30°. Our part numbers refer to the Inside Diameter of the joint (OD of the linkage rod or tube). Stepped sizes are not available. If two different diameter tubes must be joined, a bushing must be added to the smaller one. Sold individually. Apex Covered Universal Joint Dimensions Bore Size (ID) MS Part No. Overall Length Sleeve OD Sleeve Depth Static Torque Rating (Inch-Pounds) Weight (oz) Part No. 1/4" MS20271‐B6 2" 3/8" 1/2" 200 in-lb 1.2 1490-1/4 3/8" MS20271‐B8 2 5/8" 1/2" 5/8" 600 in-lb 1.5 1490-3/8 1/2" MS20271‐B10 2 3/4" 5/8" 3/4" 1080 in-lb 3 1490-1/2 5/8" MS20271‐B12 3 3/16" 3/4" 7/8" 1900 in-lb 4 1490-5/8 3/4" MS20271‐B14 3 5/8" 7/8" 1" 3000 in-lb 6 1490-3/4 13/16" MS20271‐B16 4 1/16" 1" 1 3/16" 4700 in-lb 9 1490-13/16 1 1/16" MS20271‐B20 4 5/8" 1 1/4" 1 1/8" 9500 in-lb 15 1490‐1 1/16 1 1/4" MS20271‐B24 5 1/4" 1 1/2" 1 5/16" 14,500 in-lb 18 1490‐1 1/4 If you plan to weld these joints, you need our Anti-Heat degrees Heat Sink Compound to protect the joint and boot from welding heat. If you plan to cross-bolt these joints, don't forget to order saddle washers (sold separately) to provide a proper bearing surface: Saddle Washers for #10 Bolts Saddle Washers for 1/4" Bolts